Trade data-driven transport mode selection

Engine ignition sequence: how does it affect engine performance Engine ignition sequence is Trade data-driven transport mode selectionone of the important performance indicators of the engine ignition system. It refers to the ignition time and ignition order of the cylinder under the ignition order assigned by different contactors. The correct ignition sequence can significantly improve the performance of the engine, and to a certain extent, the fuel efficiency and reliability of the engine can be improved. In this article, we will discuss the role of the engine ignition sequence, the advantages and disadvantages of different ignition sequences, and how to choose the correct ignition sequence to optimize engine performance. Function: To understand the function of the ignition sequence, we first need to understand the working principle of the internal combustion engine. The internal combustion engine ignites through the igniter, so that the fuel burns in the cylinder, pushes the piston down, and drives the crankshaft to rotate, thus driving the vehicle forward.The function of the ignition sequence is to ensure that each cylinder is ignited at the right time to minimize energy waste and mechanical wear caused by poor ignition sequence. The correct ignition sequence helps to improve combustion efficiency and reduce emissions and volume. Advantages and disadvantages of different ignition sequences: For most four-cylinder, six-cylinder and eight-cylinder engines, there are two main ignition sequences: forward ignition and cross-ignition. Next, we will discuss their advantages and disadvantages one by one: positive ignition: positive ignition is a relatively common ignition method, which refers to ignition in order of cylinder structure. For four-cylinder engines, positive ignition starts from the first cylinder and is carried out sequentially, while six-cylinder and eight-cylinder engines start from the first cylinder on the left or right and are also ignited in order. Advantages: When driving at low speed, positive ignition can ensure a more stable power output and make the vehicle accelerate more smoothly.In addition, due to the adoption of sequential ignition, the ignition system is simpler and easier to adjust. Disadvantages: Positive ignition is easy to cause the heat load overload of the cylinder, especially during high-speed operation. Due to the limitation of the ignition sequence, some cylinders can be ignited continuously for a short time, so that the volume temperature of the cylinder is too high and the wear increases. Cross-ignition: In cross-ignition, the ignition order of the cylinder is according to parity, that is, the order of the two cylinders adjacent to the ignition sequence must be reversed. For example, in a four-cylinder engine, the ignition order of the first cylinder and the third cylinder is the same, and the ignition order of the second cylinder and the fourth cylinder is the same, but the opposite of the first two. Advantages: Cross-ignition is a good balance scheme, which eliminates the shortcomings of positive ignition and provides better thermal balance. Due to the use of better thermal balance, cross-ignition can reduce the heat load of the cylinder in the engine, thus reducing the mechanical wear of the engine.Disadvantages: Cross-ignition requires a more complex ignition system, because each cylinder needs a separate ignition coil. This increases the cost and the difficulty of maintenance. Choose the correct ignition sequence: Choosing the correct ignition sequence requires consideration of multiple factors, such as engine structure, speed range and power requirements. Different engine designs require different ignition sequences to achieve the best power and fuel efficiency. For example, when the engine requires high speed and high power, cross-ignition can ensure thermal balance and reduce the early ignition or combustion delay caused by rising temperatures. However, if smoother power output and better low-speed driving performance are required, positive ignition is more suitable. In addition, different engine designs also require the cooperation of different ignition systems to achieve their best performance. Summary: The engine ignition sequence is a key indicator in the engine ignition system, which can significantly affect the engine performance, fuel efficiency and reliability.Different ignition sequences have their own advantages and disadvantages. Choosing the correct ignition sequence needs to consider the engine structure, speed range and power requirements. In actual engine design, it is necessary to carefully evaluate different ignition sequences to achieve a balance between best performance and fuel economy.

Contact Us
Phone：020-83484653