How to ensure transparency in supply chains

List of catalogs of this article:

• 1,How to ensure transparency in supply chains How to paste car stickers
• Car stickers need to be filed
• 3, body stickers cannot exceed 30% or 70% of the body
• 4, How to stick car stickers?
• 5, Is it illegal to paste patterns on car doors
• 6, How to set the actual size of car stickers

How to paste car stickers

The principle of pasting car stickers is to paste from the inside to the outside, that is, paste the middle part first, and then press it out with your finger, so that the bubbles can be pushed out. If you stick it from the outside to the inside, the bubbles will not be able to escape (at this time, you can cut the bubble part with a knife for the sake of beauty).

Prepare the sticker, as shown in the figure below: pull straight and paste the transfer film, as shown in the figure below: tear off the bottom paper of the car sticker; wipe it clean to the position where you want to stick the car sticker; stick the sticker at the end after aligning; and then push it up with a towel to the end.

) Clean the car body and sprinkle water evenly on the body part to be pasted - to reduce the viscosity of the sticker and facilitate the adjustment of the position. 2) Determine the position that needs to be pasted.While slowly pasting, gently scrape it flat with a tool, and remove the base paper. 3) When encountering door handles or anti-scrab strips, the material should be cut open and wrapped in according to the situation.

First, wash the Wuling Hongguang mini. Secondly, spray water on the car body. Then slowly stick the decal to the car body. Finally, use a scraper to scrape it flat.

Does the car sticker need to go to the record

1. There is no need to file the pattern on the car, because according to the provisions of the Road Traffic Safety Law, the owner is allowed to spray and post advertisements on the motor vehicle body, but there is a premise, that is, it cannot exceed 30% of the car body and does not affect the safety of the vehicle. Drive.

2. The car sticker needs to be filed or not. If the sticker area of the car body does not exceed 30% of the total area of the car body, it does not need to be filed. After exceeding 30%, it must be filed at the DMA, and if it is restored to its original state after filing, it needs to be filed again.

3. If the film exceeds 30%, it needs to be filed with the vehicle management office; if the area does not exceed 30%, such as just pasting a small sticker on the rear of the vehicle or pasting ornaments similar to Daula flowers on the side of the vehicle, there is no need to be registered for the record.

4. The first is that if the total area of your car sticker exceeds 30% of the land area of the car body, then you must go to the local vehicle management office for filing within ten days.

5. The first is that if the area of your car sticker exceeds 30% of the total area of the car body, you need to go to the local DMA for filing within ten days. The second situation is that the area of the car sticker does not exceed 30%, such as just pasting a small sticker at the rear of the car or pasting decorations such as Daola flowers on the side of the car, etc., which does not need to be registered for the record.

6. If the car is pasted with a transparent film, there is no need to go to the DMD for the record. If there is a color, if the color of the car body changes by more than 30%, you need to go to the DMB for the record. If the private film changes 30% of the body color, registration and filing are not allowed, and the annual inspection will not be passed.The traffic police detained the film-changed car for temporary punishment.

The body sticker cannot exceed 30% or 70%

1. 30% of car stickers is mainly calculated according to the body area of the car. If the car uses stickers, it is better not to If it exceeds 30% of the body area, if it exceeds 30% of the body area, it will not pass the annual inspection.

2. This 30% refers to no more than 30% of the body area. As a walking tool for every household, cars are an indispensable part of people's lives. The sticker area is stipulated to be no more than 30. People who love beauty like to put fashionable paper or stickers on their cars, which looks more fashionable.

3. The calculation method of 30% of car stickers is to calculate 30% of car stickers mainly according to the body area. If the car uses stickers, it is best not to exceed 30% of the body area. If it exceeds 30% of the body area, it cannot pass the annual inspection.

4. No more than 30% of the body area. There are also many car owners who like to put a layer of black film on the roof of the car, because the black film can not only play a role in heat insulation, but also protect the privacy of the car owner and improve the overall beauty of the car to a certain extent.

5. % of car stickers is mainly calculated according to the body area. If the car uses stickers, it is best not to exceed 30% of the body area. If it exceeds 30% of the body area, it cannot pass the annual inspection. In terms of appearance, if the car is pasted, the body color of the car cannot exceed two colors.There are certain requirements for changing body color.

6. The key to 30% of car stickers is to be calculated according to the body area of the car. If the car uses stickers, it is best not to exceed 30% of the body area. If it exceeds 30% of the body area, it will not be passed during the annual review.

How to stick car stickers?

1. Clean the car body and sprinkle water evenly in the local position where the car body needs to be pasted - reduce the stickiness of the sticker and facilitate position adjustment; determine where it needs to be posted. Paste gently, scrape slowly with a tool, and remove the transfer film; when touching the door handle or anti-scratch strip, cut the material and wrap it according to the situation; adjust moderately.

2. Clean the car body. Sprinkle water evenly on the part of the body that needs to be pasted to reduce the stickiness of the sticker and facilitate position adjustment.Make sure where it needs to be pasted. Stick it slowly, scrape it gently with a tool, and remove the transfer film. In case of door handles or anti-scratch strips, cut and pack according to the situation.

3. Prepare the sticker, as shown in the figure below: straighten the transfer film, as shown in the figure below: tear off the base paper of the car sticker in reverse; wipe it clean to the position where you want to stick the car sticker; after aligning, stick the sticker at the end first; then push it up with a towel to the end.

4. Installation method of small car stickers with transparent transfer film: clean the car body and keep it dry. Determine the position that needs to be pasted. Under normal circumstances, stick it slowly, scrape it flat with a tool, and remove the bottom. If the figure is really small, you can also tear off all the transparent transfer film and stickers before pasting. But you must be careful not to cause accidental adhesion.

5. Car film is applied to car glass to control sunlight and ensure safety.In addition to sunlight control, its basic safety performance includes clarity, anti-glare, ultraviolet insulation, heat insulation, anti-scrature, adhesive glass fragments, sufficient shelf life and privacy protection, ensuring safe driving performance, etc. Increase the beauty.

6. When applying the film, the most important thing to pay attention to is the use of a hair dryer. If you blow hard on this place for a long time, the glass will be unevenly heated and cracked. Therefore, you should go to those professional authorized stores for the film, so that the quality of the film can be guaranteed and the danger of glass cracking can be avoided.

Is it illegal to paste patterns on car doors

1. Legal subjectivity: It is not illegal to paste patterns on car doors, and the area should not exceed 30%. Car stickers cannot use special colors for special vehicles, shall not affect safe driving, and should be filed with the DMV.The law stipulates that those who affect safe driving by spraying, pasting signs or body advertisements for motor vehicles shall be fined.

2. Car stickers are not illegal, as long as the area is not more than 30%, car stickers need to be filed with the DM. The precautions for car stickers are as follows: car stickers shall not affect safe driving. China's law stipulates that motor vehicles will be fined for spraying, pasting signs or advertising vehicles that affect safe driving.

3. Is it illegal to stick stickers on the door? It is not illegal to stick stickers on the door. As long as the area does not exceed 30%, it is allowed, and it is also to go to the DMV for the record. In this way, the road traffic police will check and take out the driving license and have a record, and it will be released directly. The car sticker must not affect safe driving, and the content must be healthy and upward.

4. Legal analysis: Car stickers are not illegal, and the car body can be stickered, but the relevant regulations should be followed.Advertising car stickers are not allowed. Humorous and mocking car stickers are based on the premise that they do not affect other people's driving. It is illegal for personalized car stickers to exceed 20% of the area of the car body and will be punished.

How to set the actual size of the car sticker

First, take a picture of the whole car that needs to be painted (left and right sides, front and rear of the car) to measure the overall size that needs to be painted, and directly cover the finished body advertising design Enter the car that has just been photographed (Note: This step is needed by the designer in the document), and make appropriate modifications according to the shape of the car.

Measure the body size: Use the measuring tool to measure the size of the body in order to cut on the sticker. Make sure that the sticker matches the body size.Cut the sticker: According to the measured size, use scissors to cut the sticker into the size and shape suitable for the car body.

First of all, we need to determine the size and shape of the sticker. You can choose the appropriate sticker size and shape according to the design needs. Common sticker shapes include round, square, oval, heart-shaped, etc., and the shape can also be customized according to your needs. Design the sticker pattern. After determining the size and shape of the sticker, you need to design the sticker pattern.

Common sizes 20X110cm, 30X100cm, 20X125cm, etc. If one side of the length and width of the body patch is not more than one meter, but not less than 0.5 meters, it is called the middle sticker. Common sizes are 13X95cm, 20X80cm, etc.

In some areas, advertising bodies are not allowed to appear at will.For the body personalized stickers, it is recommended to control a certain size. After all, this kind of decorative sticker is only the finishing touch. After covering more area, the visual effect of the actual car shows the feeling of "car style" or "country handsome", so control it a little on the sticker.

The calculation method of 30% of car stickers is that 30% of car stickers are mainly calculated according to the body area. If the car uses stickers, it is best not to exceed 30% of the body area. If it exceeds 30% of the body area, it cannot pass the annual inspection.