Advanced trade route cost analysis

List of the table of contents of this article:

• 1,Where is the g4na engine produced
• 2、Hyundai 2.Does the 5t engine pull the cylinder?Advanced trade route cost analysis

Where is the g4na engine

g4na engine is an engine produced by Hyundai Kia, which belongs to the Korean brand. However, at present, the g4na on the market is localized, mainly installed on Kia Smart Run and Hyundai Sonata.

g4na engine is an engine produced by Hyundai Kia and belongs to the Korean brand. However, g4na is currently localized in the market, mainly on Kia Smart Run and Hyundai Sonata.

g4na engine is an engine produced by Hyundai Kia, which belongs to a Korean brand. However, at present, the g4na on the market has been localized, and it is mainly installed on Kia Smart Run and Hyundai Sonata.

How about the smart running g4nj engine

Although with some German or Japan in the market Compared with this engine, the g4na data is not conspicuous, but the fuel economy is still excellent. Equipped with the g4na Hyundai engine ix3, its fuel consumption is only about 8L/100km.

Although the g4na is less conspicuous in terms of data compared with some German or Japanese engines on the market, it is still excellent in terms of fuel economy. Hyundai ix35 equipped with g4na engine, its fuel consumption is only about 8L/100km.

But it is still excellent in terms of fuel economy. Hyundai ix35 is equipped with a g4na engine, and the fuel consumption is only about 8L/100km.

g4na engine common disease

The engine oil storage is too small, resulting in no oil or little oil in the lubrication system, resulting in low oil pressure. Solution: Refueling. The oil is dirty or sticky, causing the oil pump to effectively inhale and pump out the oil, resulting in low or no pressure on the oil.Solution: Change the oil.

will. The 2013 Kia Jiale will pull the cylinder, and the 13 Kia's new Jiale, some G4NA engine design shortcomings, due to the lack of the middle cylinder assembly, the oil injection nozzle causes some vehicles to pull the cylinder when the cold start.

However, it should be noted that Hyundai Motor issued a recall announcement of the engine's big brother G4NA in 2019, because of the engine had a cylinder pulling problem, which also proved that the G4NA engine had very serious design defects. There is no official reply so far.

However, on the 3rd of December, the staff of Yingkou 4S store called to inform the vehicle that the engine assembly could not be replaced, but only the cylinder block could be replaced. Now the Hyundai 4s store in Beijing is required to replace the engine assembly. We now appeal to protect the legitimate rights and interests of our consumers.Nowadays, many car owners have the phenomenon of pulling the cylinder. I hope everyone can go to the car quality network to protect their rights.

What is the model of the 2010 Hyundai ix35 engine

1. The model of the Hyundai ix35 engine is G4NA. The maximum horsepower of the engine is 163Ps, the maximum power is 120kw, the maximum torque is 194nm, and the air intake form is naturally aspirated.

2. Hello, it's different. The 10 models with 0L displacement use the G4KD engine, and the 13 models use the G4NA engine.

3. The engine model of Beijing Hyundai ix35 is G4NA. The new Beijing Hyundai ix35 has launched a total of 8 models, with a price range of 1.9-1.19 million yuan.Compared with the old model, the biggest change is the addition of the 4T version.

10 Hyundai ix35 uses NU or VVT engine

Don't listen to the nonsense on the first floor. There are two kinds of engines of 35. The old one is a pure shackle engine. The latter is a NU modified machine. The old shackles are a joint venture. The latter NU series machines are purely imported, but it is difficult to say whether it can be a joint venture in the future.

Hyundai ix35 uses two engines, one is a 4-liter turbocharged engine and the other is a 0-liter naturally aspirated engine.

The modern ix35 uses two engines, one is a 4-liter turbocharged engine, and the other is a 0-liter naturally aspirated engine.The maximum torque of a 4-liter turbocharged engine is 140 horsepower and 242 Nm. This engine can output maximum power at 6000 rpm and maximum torque at 1500 to 3200 rpm.

Theta second-generation double CVVT all-aluminum structure four-cylinder gasoline engine.

Hyundai ix35 is equipped with Kappa4T engine. Hyundai ix35 is an SUV model. Hyundai ix35 will be officially introduced into the domestic market in 2010 as a replacement model of Tucson. Beijing Hyundai has said that the domestic version of the ix35 will not follow the "Tucson" as the model name.

Hyundai 2.5t engineDoes it pull the cylinder?

Modern Mingtu engine does not pull the cylinder much. In fact, cars rarely pull the cylinder. Pulling the cylinder is mainly related to the driver's driving habits and car maintenance.

Hello, car owner, if it is serious, it will cause the engine to pull the cylinder shaft and die. I hope my answer will be helpful to you. If you have any questions, you can continue to ask me. I wish you a happy life [If you have any questions about the car, ask the car master. 4S store professional technician, 10 minutes to solve.

It may be because the engine lubrication efficiency is poor and the lubrication cannot be in place. In this case, contact the 4S store for testing and maintenance. There are many reasons for pulling the cylinder. The engine temperature is too high, the carbon accumulation and falling off, the lubricating oil is not qualified, and the high speed for a long time will all cause the engine to pull the cylinder.

The modern cylinder king is ix35.The previous 2013 ix35 has complaints about pulling the cylinder, mainly on the 0L naturally aspirated models. There are many reasons for the engine to pull the cylinder, the most important of which are the engine cooling system, the oil lubrication system, and the working performance of the supply system.

Modern engine pull-up cylinder. Check whether there is any abnormal noise, and learn to distinguish the abnormal noise that belongs to the reasonable noise. It is difficult for ordinary car owners to distinguish which are faulty abnormal noises and which are reasonable abnormal noises. When I went to the repair shop to test the abnormal sound of the vehicles, only nearly 20% of the vehicles really had problems.