Pre-export HS code verification steps

List of catalogs in this article:

• 1. Where is the window glass of the car
• 2、 How to replace the side windshield of the car?
• 3, How to deal with someone installing fake car glass
• 4. How should car glass be replaced? Introduction to car glass replacement
• 5, How to replace the car glass?
• 6, How is the rear windshield of the car installed

Where is the film applied to the window glass of the car

1. The window film is stuck inside. In general, the car film is pasted on the inside of the glass. So as to avoid the destruction of the adhesive film by the external environment. If the front windshield film is attached to the outside of the glass, the film and the wiper will be scratched when using the wiper, thus damaging the front windshield film.

2. Stick it inside the vehicle glass. In order to avoid the harm of the external environment to the film. If the front windshield is attached to the outside of the glass, when using a wiper, the film and the wiper will scratch, which will damage the front windshield.

3. When applying the glass film of motor vehicles, the pasted glass film needs to be pasted on the inside of the glass to have a very good use effect. Motor vehicle glass film can effectively play a role in protecting privacy, reducing temperature and protecting safety.

4. The car film should be pasted on the inner side of the car glass, because the inner side will not be affected by wind and rain, and the aging will be slower, thus prolonging the service life; at the same time, the film will not be affected by too much external interference during the use, will not be broken, will not experience wind and rain, and the paste will be firmer. There will be no starting angle or something like that.

5. Car film is to paste a layer of film objects on the front and rear windshields, side window glass and sunroof of the vehicle, and paste it inside the glass. It can block ultraviolet rays, block some heat, and prevent the glass from suddenly bursting and causing personal injury. At the same time, personal privacy can be protected according to the one-way perspective performance of the solar film.

How to replace the side windshield of the car?

Replace it in car 4S stores; it can be replaced in places that sell car glass; some auto repair shops have cooperative car glass replacement stores. Many domestic manufacturers use Fuyao glass, and of course there are also other brands, such as Saint-Gobain, Xinyi, etc.

When replacing the sunroof glass, remove it together with the sealing rubber ring and install it according to the opposite steps of disassembly. Precautions for replacing car glass: In order to prevent air leakage, do not wash the car within three days, and tear off the tape that fixes the position of the windshield after three days. Try to avoid too many bumpy sections of the road to prevent the windshield from shifting.

When installing the windshield, pay attention to there are two small brackets on the car to support the windshield. Make sure to support the windshield with a small bracket.

Use special or suitable wiper blads and replace them immediately (usually once a year) to prevent scratching the front windshield; always adhere to the hygiene of the front windshield. If debris is stuck, try not to handle it with a wiper. Try your best to take them away carefully with a towel or something else. It is necessary to use glass water in cars.

How to deal with someone who installs fake car glass

1. For civil tort, in addition to ordering the infringer to bear civil liabilities such as stopping infringement, eliminating the impact, apologizing, and compensating for losses according to law, it can also According to the specific circumstances of the case, the perpetrator shall be given necessary sanctions such as confiscation of illegal income, fines or detention in accordance with the law.

2. If the actor is already bornThe production of counterfeit registered trademark goods and the sale of such goods shall be punished with the crime of counterfeiting a registered trademark. If it is only sold, it is suspected of selling counterfeit registered trademark goods.

3. Counterfeit or sub-factory glass is generally just a piece of light plate glass. When replacing, you need to remove the mirror support of the broken glass and then stick it to the new glass with special glue. You have to be careful when you see this scene. Glass without mirror brackets is likely to be counterfeit or cheap products.

How should car glass be replaced? Introduction to car glass replacement

1. Replace triangular glass. Some triangular window glass is glued together with glass glue like a windshield, and some are fixed with screws and screws. First of all, this kind of vehicleYou need to find the screws and the position of the screws, most of which can be seen under the seal, and the bolts are installed under the interior panel.

2. The door glass is actually very easy to replace. The main work is to remove the door interior panel. Pay special attention not to damage the door interior panel. The specific practice is as follows. First, find and remove the hidden bolts; remove the latch and boldly remove the door interior panel; adjust the window, remove the glass fixing bolt, and take out the glass.

3. Replace it in the car 4S store; it can be replaced in the place where car glass is sold; some auto repair shops have cooperative car glass replacement stores. Many domestic manufacturers use Fuyao glass, and of course there are also other brands, such as Saint-Gobain, Xinyi, etc.

4. When replacing the car glass, the negative pole of the battery should be, the terminal can only disconnect the cable, and then remove the hidden bolts, remove the lock and the decorative panel in the door. Adjust the window and remove the glass fixing bolt to take out the glass. After this step is completed, the process of replacing the car glass can begin.

How to replace the car glass?

1. How to replace different car glass: replace the window glass. Find the invisible bolts of all windows and remove them; remove the latch and remove the inside of the door panel. Dismantling the door and interior is a key step in changing the window.

2. The door glass is actually very easy to replace. The main work is to remove the door interior panel. Pay special attention not to damage the door interior panel. The specific practice is as follows. First, find and remove the hidden bolts; remove the buckle and boldly remove the door interior panel;Adjust the window, remove the glass fixing bolt, and take out the glass.

3. Replace it in the car 4S store; it can be replaced in the place where car glass is sold; some auto repair shops have cooperative car glass replacement stores. Many domestic manufacturers use Fuyao glass, and of course there are also other brands, such as Saint-Gobain, Xinyi, etc.

How to install the rear windshield of the car

1. Method/Steps First, slowly remove the black protective strip around the windshield with a flat mouth driver, and then remove the protective cover under the windshield. Use a steel wire strip through the sealant under the windshield. One person is in the car and one person is outside. Pull back and forth, slowly pull the sealant open until the sealant around the entire windshield is pulled open.

2. First of all, put the glass adhesive strip on the glass below, and then find a thin hemp rope and put it in the adhesive strip groove. Secondly, there is a person inside. The person outside put the glass on the cab and holds it hard. The person inside pulls the rope hard.

3. After installing the new rear windshield, an electric heating wire for defrosting and defogging is generally installed on the rear windshield. After that, they will conduct a test to ensure that the electric heating wire works normally. Finally, they have to clean the rear windshield and the rest of the car glass.

4. Replace the windshield: find a thin wire, commonly used organic cover wire, fine steel wire, etc., and remove the glass. Remove the original sealant. Apply the new sealant evenly and install the glass.

5. Find professional installers. Although it is not complicated, it is difficult to install by yourself.